Door-Edge Paint Chip Repair
A small chip on a painted door edge is often a local repair: the aim is to place a controlled amount of colour where paint is missing. Check the condition of the edge first, especially if the impact has exposed metal or lifted the surrounding coating.
View fine-tip touch-up paint, view brush-bottle paint or ask about your repair before choosing the pack.
Inspect the edge with the door open
Wash and dry the area, then look at the outside face, the narrow edge and the return inside the door. Use good light to check whether the mark is transferred material, missing paint, loose coating or damage extending around the edge.
A dented or distorted edge needs assessment before coating. Brown staining, bubbling or rust below lifting paint may extend further than the visible chip. Touch-up colour does not remove corrosion or restore weakened metal. Ask for a repair assessment if the metal is pitted, perforated or the surrounding paint will not stay sound.
Choose the correct paint reference
For an original body-coloured door, start with the manufacturer's full body-paint code. Include every letter, number and specified suffix. If the door has been replaced or repainted, tell us before ordering because a factory reference may not describe its current finish.
Find your paint-code reference or use the vehicle-registration ordering route. A registration identifies the vehicle and supports the order; it does not itself confirm the exact paint currently on the door.
Use the smallest suitable applicator
A fine-tip applicator can help with a narrow line of missing paint. A small brush can suit a slightly wider chip. Practise on a separate piece so you can control how much paint the applicator deposits before approaching the door.
An aerosol spreads colour much more widely and is usually unnecessary for a tiny edge chip. If the repair extends across the door face, includes a crease or needs a uniform full-panel finish, compare professional repair with a local touch-up rather than enlarging the job without a plan.
A careful approach to a small edge chip
- Clean and inspect. Remove suitable contamination as directed by the coating system. Do not sand a large area around a small chip.
- Check the base. Loose paint, corrosion or a damaged seam must be dealt with correctly. Prime exposed material only with a suitable primer where the system requires it.
- Test separately. Apply the required coating stages to a suitable test piece and compare the dried result beside the clean door in daylight.
- Place small amounts inside the chip. Keep paint off sound adjacent surfaces and build thin applications within the supplied recoat windows.
- Finish and cure. Complete the specified finishing stage. Keep the repaired edge from rubbing against nearby surfaces while the coating cures.
Do not try to flatten a fresh raised repair with compound. Follow the product's curing and aftercare instructions before washing, polishing or fitting anything over the edge.
Choose a pack by what is included
Compare paint packs to check the applicator, primer and finishing products actually supplied. The preparation depends on the exposed material and paint system, so a larger kit is not automatically the right choice for a smaller chip.
Read the stone-chip repair guide for further local application advice and paint aftercare before using the repaired area normally. For uncertain corrosion or a previous repair, send photographs first.
Updated 17 November 2026. Follow the instructions supplied with your selected paint system.